১০০ × ১৫০ মিমি ছবির জন্য ৯৪ × ১৪৪ মিমি জানালা রাখলে চারপাশে ৩ মিমি করে ঢাকবে। এই অংশে মুখ বা লেখা কাটা যাচ্ছে কি না আগে কাগজের ম্যাট দিয়ে দেখুন।
A photo frame that accepts replaceable mats can serve several print sizes without replacing the entire frame. The front opening, the pocket that holds the photograph and the backing panel do three different jobs. If you use the photograph dimensions for all three, its edges may fall through or a face near the edge may be cut off. Start with a paper mat and the actual print before preparing separate plate layouts.
View Product · Smooth PEI Plate
Measure the photograph you have
Place the physical photograph on a clean surface. Measure its width and height, including any white border. Crop names and print service descriptions are useful labels, but the physical print is the object that must fit. Mark a reference on a paper mockup showing which edge is up. If you want the same frame to accept both portrait and landscape images, check how the stand or hanging arrangement works in both positions.
Work out the overlap on each side
For an illustrative 100 by 150 mm photograph and a centred 94 by 144 mm opening, the mat covers 3 mm along each edge. That follows from subtracting the opening from the print and dividing the remaining dimension by two. Hold the paper opening over the intended photograph. A symmetrical border can still crop someone’s hair or part of a caption, so adjust the opening or position based on the actual subject.
Separate the pocket from the mat opening
The rear pocket needs enough room for the print and any protective sleeve or backing chosen for the project. Its size is different from the visible opening. Use a spare print or a card of the same size to test loading. Design an accessible way to remove the backing without pushing directly against the photograph. Pay attention to any raised corner or rough edge that could mark the print during repeated changes.
Test one corner of the stack
Print a short frame corner, a matching mat corner and a section of the backing. Use the same orientation and approved smooth PEI setup intended for the final parts. Assemble them with the sample card between them. Check whether the backing seats fully, whether the mat lies flat and whether the paper slips behind a corner. One cross section answers these questions more cheaply than printing a whole decorative frame.
Organise layouts by what will change
Keep the common frame and backing in one project group and give each mat its own identifiable size. Mark the mat’s back with its opening dimensions if space permits. A customer asking for another mat can then describe the image they want to show. You can alter the visible opening while keeping the verified connection to the existing frame.
Do a real picture change before delivery
Install the intended photograph, view it upright and inspect its edges from an angle. Remove it and replace it with another sample using the same steps the customer will follow. Look for movement, visible gaps and scuffs on the sample card. Pack the frame with a small instruction showing which piece lifts first. Keep the accepted mat opening and rear pocket measurements as separate fields in the job record.

আরও পড়ুন বড় মডেল ভাগ করার আগে জোড়ের নমুনা পরীক্ষা
Artin3D | Where Ideas Take Shape.
WhatsApp or Call +880 1845 348757
www.artin3dbd.com
South Banasree Dhaka 1219



